|
Permits Department

Read the following conditions carefully, then
click the "I Agree" button near the bottom
of the page to fill out the appropriate forms.
RESIDENTIAL DRIVEWAY PERMIT CONDITIONS
- This permit is issued on the condition that licensee and any
person working under the authority of this permit shall comply
with the requirements of Act 52 of the PA of 1974 - CALL MISS
DIG BEFORE YOU DIG - Phone 248-647-7344.
- PRECAUTIONS: During the progress of any work undertaken
within the limits of said highway in pursuance hereof, the Licensee
shall provide watchmen and flagmen as may be required for the
safety and convenience of the public and/or as shall seem advisable
to this Board; and shall furnish all barricades, signs and lights
necessary to protect the public and/or such additional barricades,
signs and lights as required by the Board. Traffic shall be maintained
at all times unless otherwise indicated hereon by special endorsement
of the Board's duly authorized representative.
- ACCIDENT LIABILITY AND INDEMNIFICATION: The said Licensee
shall be liable for all damages, both to property and to persons,
resulting from accidents which may occur as a result of the proposed
operations in pursuance hereof. The Licensee shall save harmless
and indemnify the Board and the County of Oakland from any claim
for damages of any nature whatsoever which may arise out of his
operation under this permit and upon request, furnish proof of
insurance coverage for the term of this permit.
- WORK WITHIN CORPORATE LIMITS OF CITIES, VILLAGES OR TOWNSHIPS:
Licensee shall be responsible for securing and shall secure, any
other permits necessary or required by law from cities, villages,
townships, corporations, or individuals.
- BONDS: The Licensee shall upon request, file a bond acceptable
to the Board of Road Commissioners for Oakland County and conditioned
upon performance of the conditions of the permit and compliance
with all requirements of law.
- VIOLATION: The violation of any condition of this permit
by the said Licensee shall constitute a forfeiture of rights hereunder.
- REVOCATION OF PERMIT: It is to be understood that the
rights granted herein are revocable at the will of the Board and
that the Licensee acquires no rights in the highway and expressly
waives any right to claim damages or compensation in case this
permit is revoked.
A copy of this permit shall be kept on the work site, subject
to inspection at all times by the Board or any of its duly authorized
agents.
STANDARD SPECIFICATIONS:
- DRIVEWAY DIMENSIONS: The width at property line shall
be at least 10' but not more that 25'. If the road is curbed,
the width of the curb opening shall be as shown on the face of
the permit but shall not be less that 14' or more that 50'.
- DRAINAGE: The driveway shall be constructed so that the
drainage is not adversely affected by the driveway. The drainage
and the stability of the road subgrade shall not be altered by
driveway construction or roadside development. All culvert pipe
used shall be a size adequate to carry the anticipated natural
flow of the ditch; the culvert shall be no smaller than the size
determined by the Permits Department, nor shall it be less that
12" inside diameter. Culvert length shall be at least 22" but
not more than 36'. Except for driveways, the enclosure of ditches
will not be permitted. The use of headwalls on culvert ends will
not be permitted. The use of sloped end sections is encouraged.
- SURFACING: When the road is paved, driveways shall be
paved between the edge of pavement and the existing or proposed
sidewalk. If there is no existing or proposed sidewalk, the surfacing
shall extend at least 10' from the edge of pavement or to the
right-of-way line, whichever distance is greater. When the road
is unpaved, paving the driveway is not required. If such driveway
is to be paved, the paving shall extend no closer to the road
than one foot behind the driveway culvert location. Driveway pavement
shall be a minimum of two inches of bituminous surfacing on a
gravel base or six inches of concrete.
- DRIVEWAY GRADE: If the road is uncurbed, the grade of
the driveway between the road edge of the pavement and the edge
of the shoulder shall conform to the slope of the shoulder. If
the road is curbed, the grade shall not exceed 10% (10' per 100')
upward or downward from the road.
<< Back
to Permits
|